A - Charging The Battery With An External Battery Charger (Fig. G); B - Battery Charging With On-Board Battery Charger (If Present) (Fig. G); Machine Controls; A - Control Panel (Fig. F) - Ghibli & Wirbel RACER R 85 FD 65 Manual De Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
5.1.a - Charging the battery with
an external battery charger
(Fig. G)
- Check the function of the battery charger
consulting the corresponding Manual.
- The nominal voltage of the battery charg-
er must be equal to 24 V.
- Take connector (39) from the appropriate
housing (38) and connect it to the external
battery charger.
- Connect the battery charger to the electri-
cal network.
- When the recharging is finished, discon-
nect the battery charger from the network
and from connector (39).
- Lower the recovery water tank carefully
(11).
5.1.b - Battery charging with on-
board battery charger (if
present) (Fig. G)
- From the appropriate housing (38), take
and connect the plug of the battery charg-
er cable (40) to the electrical network (the
network voltage and frequency must be
the same as the corresponding values
of the battery charger, shown in the ma-
chine's registration plate).
NOTE:
When the battery charger is connected to the
electrical mains, all machine functions are
automatically disabled.
- On the display (41 Fig. F), when the seg-
ments light up in sequence on the bat-
tery symbol , this means that the battery
charger is charging the batteries.
- When all the segments in the battery
symbol are lighted up steadily, the battery
charging cycle has ended.
- Disconnect the battery charger cable (40)
from the electrical network and insert it
into the appropriate housing (38).
- Lower the recovery water tank carefully
(11).
6 -

6.1 - MACHINE CONTROLS

6.1.a - Control panel (Fig. F)
(29) Ignition key
- Turned in a clockwise direction to "ON" it
powers the circuits, enabling machine op-
eration.
- Turned in an anti-clockwise direction to
"OFF" it disconnects power to the circuits
and can be removed.
(30) Buttons for maximum speed
adjustment
It is possible to adjust the maximum travel
speed using buttons (30a) "
" ".
- Pressing the accelerator pedal (7) com-
pletely, the speed will be adjusted propor-
tionally to the maximum set value.
- When all speed symbols "
on the display (41), the accelerator pedal
(7) is inhibited and the machine remains
stopped.
(31) Travel direction buttons
- When the forward button (31a) "
pressed, the machine travels forward; the
icon " " shows up on the display.
- When the backward button (31b) "
is pressed, the machine travels backward
and the backward motion buzzer is actu-
ated; the icon "
play.
NOTE:
The maximum backward speed can be set,
as in the forward travel, with buttons (30).
ENGLISH - 7
" and (30b)
" are lighted
" shows up on the dis-
" is
"