www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Washing, brushing, drying cycle:
- Press the button "Ready to go" (42) "
to prepare the detergent flow, the brushes
rotation and the start of the suction device.
Drying only cycle:
- To perform only the drying cycle press the
button (44) "
", the aspirator activates.
Brushing only cycle:
- To perform only the brushing cycle press
the button (46) "
tion is prepared.
- Brushes rotation starts when the machine,
with the accelerator (7) pressed, starts
moving forward or backward, or with the
accelerator pressed and setting the for-
ward speed to "0".
Washing, brushing cycle:
- Press the button (46) "
brushes rotation and press the button (49)
"
" to prepare water supply.
- The brush rotation and the water flow start
when the accelerator pedal is pressed
with the forward or backward gear, or with
the setting of the advance speed at least
on the 1st notch.
11.1.c - Using the machine
DANGER:
Be extremely careful when using the
machine on ramps in order to avoid
roll over or situations which may
cause the machine to lose its bal-
ance.
"
", the brushes rota-
" to prepare
ENGLISH - 13
DANGER:
Avoid sudden sharp turns. Turn the
wheel from lock to lock only at low
speed,
always considering ground
conditions.
- Turn the key (29) to "ON"; in the first 2
second after turning on, the display (41)
indicates the type of batteries installed
and the machine work time.
- Select the type of work cycle to be fol-
lowed.
- Insert the desired work speed acting on
buttons (30).
- Activate the flashing light (10, optional)
and the work light (9, optional).
- Use the accelerator (7) to begin the clean-
ing operations.
NOTE:
Release the accelerator to stop the rotation
of the brushes and the dispensing of water.
NOTE:
Proper floor cleaning and drying is performed
by driving the machine forwards. When driv-
ing in reverse, the squeegee is raised and
the suction unit, for removing the water from
the floor, is deactivated.
- Adjust the washing solution quantity with
the button (49) "
- Check the charge status of the batteries
on the display (41).
" if its necessary.