A - Battery Installation (Fig. A); B - Unloading The Machine From The Wooden Pallet (Fig. B); Assembly Components; A - Squeegee Installation (Fig. C) - Ghibli & Wirbel RACER R 85 FD 65 Manual De Uso Y Mantenimiento

3.1.a - Battery installation (Fig. A)
- Lift the recovery tank carefully (11).
- Depending on the configuration (4 6 V
batteries, 2 12 V batteries, 1 package of
24 batteries), position and connect the
batteries as shown in figure, using the ca-
bles and plugs provided.
- Lower the recovery water tank carefully
(11).
NOTE:
The batteries must be installed and connect-
ed by qualified personnel.
3.1.b - Unloading the machine from
the wooden pallet (Fig. B)
- Remove the wooden block (27) positioned
in front of the front wheel.
- Place the ramp (28) in front of the wooden
pallet as indicated in the instruction sheet
on the packaging.
- Sit on the seat (3) in driving position.
- Turn the key (29) on "ON".
- Press the travel direction button (31a) "
" (forward travel), then carefully
press the accelerator pedal (7) and step
off the pallet.
4 -
4.1 - ASSEMBLY
COMPONENTS
4.1.a - Squeegee installation (Fig.
C)
- Insert the squeegee (20) into its support
plate (35) and fasten it by tightening the
two knobs (36).
- Connect the suction tube (16) to the
squeegee's intake opening (37).
4.1.b - Brushes installation
- See procedure in the "13.4.a - Brushes re-
placement (Fig. M)" paragraph.
5 -
5.1 - CHARGING THE
DANGER:
Charge the batteries in rooms which
are well-ventilated and comply with
applicable regulations in the country
of use.
For safety-related information, follow
what is described in chapter 1 of this
manual.
WARNING:
For information and warnings about
the battery and on board battery
charger (if present) follow what is de-
scribed in the battery charger manual
enclosed with this document.
WARNING:
When the machine leaves the factory,
it is calibrated to operate with gel bat-
teries. If other types of batteries are
installed, see the paragraph "Param-
eter setting".
The use of gel batteries with calibra-
tion for acid or other batteries is pro-
hibited.
NOTE:
10 hours are needed for complete battery
charging. Avoid partial recharges.
Charge the batteries at the end of each job or
at least when the battery symbol "
the display (41 Fig. F) starts flashing.
- Drive the machine to the battery charging
station.
- Lift the recovery water tank (11) making
sure it is empty.
ENGLISH - 6
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
BATTERY
" on