Adjustment Of The Miter Angle; Clamping The Workpiece; Setting The Saw Band Guide; Setting The Blade Tension - HOLZMANN MASCHINEN BS 115 Manual De Instrucciones

14.4.5 Adjustment of the miter angle

Loosen the clamping screw (5).
▪
Now you can move the entire saw arm.
▪
By tightening the clamping screw (5) that is fixed again.
▪

14.4.6 Clamping the workpiece

Place the workpiece in a vice and tighten it with the hand wheel (7) to.
▪

14.4.7 Setting the saw band guide

Adjust the guide so that it approximately 2 cm in front of the
▪
workpiece.
Loosen the hand wheel (8) and slide the guide.
▪
Pull the handwheel back up again
▪

14.4.8 Setting the blade tension

The bandsaw blade with the control knob (10) to voltage (2 - 3mm Test) set.
▪
Check after a short test run and retighten if necessary.
▪

14.4.9 Start/ Stop

Switch ON / OFF:
The machine can be switched on via the green ON button switching on and off with the red OFF
switch button.
The automatic switch off can by readjusting the limit screw to
be adjusted.
- Allow the engine to start up fully so that the saw blade at full
running speed.
- Run the saw arm to the bracket (3) to the workpiece.
- Let the saw arm by its own weight work through the
material.
- Do not apply pressure. The saw automatically turns off after
cutting through the material by triggering the OFF switch
button.
The motor must run to full speed before start cutting!
HOLZMANN MASCHINEN GmbH
N O T E
www.holzmann-maschinen.at
Adjusting limit screw
53
BS115 / BS128HDR