Grinding Mode; Standard Mode; Automatic Mode; Pre/Sel Mode - Fiorenzato XGR Manual De Instrucciones

• IMPORTANT: fasten the grinding adjust-
ment disk correctly (refer to the chapter
AUTOMATIC RECOGNITION OF THE FIL-
TER HOLDER CUPS – RFID).

GRINDING MODE

Using the SETTINGS menu, you can now se-
lect from the various MODES OF USE for the
grinder-doser. For certain modes, where pro-
vided, the dose of coffee dispensed from the
coffee grinder-doser will be exactly the dose
set and calibrated (XG Technology).

STANDARD MODE

Press for the required dose using the but-
tons C1 or C2 (automatic operation for XGR
models). The selected button will begin to
flash. When the filter holder cup is pressed,
the start microswitch activates grinding.
Otherwise, pressing the button M, continu-
ous grinding is activated until the button is
released. The standard mode is factory-set.
To reselect it, access the SETTINGS menu,
select GRINDING MODE and then STAND-
ARD. In this way, the buttons will light up.

AUTOMATIC MODE

Access the SETTINGS menu, select GRIND-
ING MODE and then AUTOMATIC. For a sin-
gle dose, press the start microswitch once
with the filter holder cup. For a double dose,
press twice quickly (this last operation is not
necessary for XGR models). In this way, the
continuous grinding (button M) and the but-
tons C1 and C2 are deactivated.

PRE/SEL MODE

Access the SETTINGS menu, select GRIND-
ING MODE and then PRE/SEL. Press the
required dose using button C1 or C2 (au-
tomatic operation for XGR models). The
selected button will remain on and active.
Grinding starts when the start microswitch
is pressed by the filter holder cup. To switch
from one dose to another, press the appro-
priate button. In this way, continuous grind-
ing (button M) is deactivated.

DIRECT MODE

Access the SETTINGS menu, select GRIND-
ING MODE and then DIRECT. Press the re-
quired dose by using the button C1 or C2
(automatic operation for XGR models). Oth-
erwise, pressing the button M, continuous
grinding is activated until the button is re-
leased. In this way, the start microswitch is
deactivated and the buttons light up.
• During the grinding process, the time is dis-
played in seconds and tenths of a second.
• The button for the selected dose flashes
during dispensing.
• After dispensing, the counters are updated.
• For counting purposes, continuous grind-
ing corresponds to a single dose.

SAFETY DEVICES

THERMAL OVERLOAD PROTECTION
The grinder-doser motor is protected against
overheating resulting from overcurrents
by a thermal overload protection which,
when tripped, cuts off the power supply to
the motor. If the thermal protection device
should automatically turn on in the event
of anomalous operation (such as the grind-
ing blades jamming), turn off grinder-doser
using the On-Off switch, unplug it from the
mains, and contact skilled technical person-
nel. Never perform any work on the grind-
er-doser while it is attached to the mains,
in order to prevent the motor from turning
on suddenly. If the grinder-doser overheats
as a result of the motor stopping, allow the
grinder-doser to cool down before perform-
ing any repair work.
ADJUSTMENT DISK LOCK
In order to prevent the adjustment disk
from being removed, which would make the
rotating parts accessible, there is an anti-
unscrewing adjustment disk lock (safe) po-
sitioned under the adjustment disk.
29