PRELIMINARIES
Make sure the hopper is positioned correctly
on the coffee grinder-doser and is fastened
to the upper grinding blade holder by means
of the relevant screw. Close the locking slide
and fill the hopper with coffee beans. Open
the locking slide so that the beans are al-
lowed to drop into the grinding system.
Hopper safety screw
SWITCHING ON AND OFF
On: set the switch to 1.
Off: set the switch to 0.
LED INDICATOR LIGHT ON LEFT SIDE
OFF: grinder off.
ON: grinder on.
FLASHING: the grinder is grinding (the mo-
tor is working).
CALIBRATION PLATE LED
When you switch on the coffee grinder-dos-
er, you will notice that the LED indicator light
on the front of the calibration plate will light
up, flashing a few times in different colours:
BLUE: switched on
GREEN: RFID connected
(only for XGR models).
WHITE: scales connected.
During other operations, this LED indicator
light may change to the following colours:
ORANGE: in programming menu.
PURPLE: in calibration menu.
RED: indicates incorrect RFID detection
(only for XGR models).
SELECTION BUTTONS
The control panel has three blue LED but-
tons for selecting the quantity required for
grinding. When pressed, an acoustic sound
is released:
C1: single dose.
M: continuous manual grinding.
C2: double dose.
C1
DISPLAY
When the grinder-doser is switched on, the
display shows, on the LEFT, the tempera-
ture, the number of coffees made through-
out the day (Today), during the current
week (Week) and the Total. On the RIGHT, it
shows the percentage of humidity, the time,
the date and the grinding mode selected in
green. The radio and/or scales signal sym-
bols, indicating the presence of XG and XGR
technoloiges (refer to paragraph XG/XGR
TECHNOLOGIES), are shown AT THE TOP IN
THE CENTRE.
26 °C
Today: 76
Week: 355
Total: 1571
USER MENU
To access the user menu, keep the C1 button
pressed until an intermittent sound starts
(about 5 secs.). Three yellow buttons will
25
M
C2
44%
10:30 am
Wed 1 Oct 2014
Standard