Range Control, Eco Mode, Paging Function 19 Volume Control And Vibration Alert - Reer Rigi Digital Manual De Uso

Battery operation
As soon as the batteries are too weak, the status LED in the switched on state begins to
flash red. If the device is not connected to a power supply, the connection will worsen
and eventually cut off automatically. Rechargeable batteries can be charged directly in the
baby monitor. To do this, connect the device to the wall power supply using the supplied
mains adapter. The batteries take approximately 10 hours to charge (with the device
GB
switched off ).
Range control
This baby monitor is equipped with an optical and acoustic range control system. At
regular intervals, check the baby unit and the parent unit for two-way communication
(also in standby mode, if the baby unit is not receiving any noise). If the range is exceeded,
the status LED on the parent unit begins to flash red and an alarm tone sounds at regular
intervals.
ECO mode
As soon as you place the parent unit in a fixed location where you have already checked
the reception, we recommend that you switch on ECO mode (quickly press the ON/OFF
button 3 times). This will switch the unit to standby mode which involves lower power
consumption and radiation emission (if your child is asleep). The baby monitor only
transmits when it perceives noise. The range control is maintained in ECO mode.
PAGING function
Press the on/off switch briefly to activate the paging function of the baby unit. It triggers
an acoustic signal from the parent unit. This makes it possible to find the parent unit if it
has been misplaced.
Volume control and vibration alert/parent unit
To increase or decrease the receiver volume on the parent unit, press + (for louder) or - (for
down). If the lowest volume level is reached (a short beep), the vibration alert is switched
on automatically! The vibration alert is switched off automatically as soon as you press the
'+' button (to increase the sound volume).
© Copyright Gebrauchs.info
19