Range Control, Eco Mode; Volume Control / Parent Unit - Reer Rigi 400 Manual De Uso

Battery operation
As soon as the batteries are too weak, the status LED in the switched on state begins to
flash red. If the device is not connected to a power supply, the connection will worsen
and eventually cut off automatically. Rechargeable batteries can be charged directly in the
baby monitor. To do this, connect the device to the wall power supply using the supplied
mains adapter. The batteries take approximately 10 hours to charge (with the device
GB
switched off ).
Range control
This baby monitor is equipped with an optical and acoustic range control system. At
regular intervals, check the baby unit and the parent unit for two-way communication
(also in standby mode, if the baby unit is not receiving any noise). If the range is exceeded,
the status LED on the parent unit begins to flash red and an alarm tone sounds at regular
intervals.
NOTE: To activate range control, ECO mode must be switched off on both devices.
ECO mode
As soon as you place the parent unit at a fixed site at which you have checked reception on
a previous occasion, we recommend that you switch ECO mode on. IIn ECO mode, range
control is switched off and therefore in standby mode (whenever your child is quiet) the
baby unit does not emit any radiation. The baby unit then goes to send only when noises
are received.
NOTE: To activate ECO mode, ECO mode must be switched on at both devices.

Volume control / parent unit

Turn the volume switch („volume") up or down to increase or reduce the receiver volume
of the parent unit.
NOTE: If the volume is turned all the way down, no sound will be transmitted.
19