Before First Use; Insert Battery; In 1: Baby Monitor Or Walkie Talkie Operating Modes - Reer Care&Talk 50133 Instrucciones De Uso

Before first use

Insert Battery

1. Remove the belt clip. Pull the eye and pull the belt
clip downward.
2. Open the battery compartment by releasing it and
removing the screw with a screwdriver and with
light pressure and a parallel sliding movement
downward, remove the compartment.
3. Carefully connect the Li-Ion battery plug to the
female connector in the battery compartment (red
lead on the right).
4. Insert battery into device. Both cables should be
between battery and male connector.
5. Slide the cover back onto the battery compartment back and screw it on again.
6. Connect the two chargers with the power supplies that are included in the purchase and
plug them into a 230 V outlet.
7. Place the devices into the charger. During charging, the line blinks on the charg-
ing status indicator light and the light on the charger is red.
Warning: Before first use, fully charge both devices until the charging status light shows 3
lines. During first charging, this can last 4 hours.
When the battery is fully charged, the message „FULL" appears on the display.
You can also charge the battery without a charger directly via the micro USB charging con-
nector on the device.

2 in 1: baby monitor or walkie talkie operating modes

Do not forget that due to the two functions of the device, this instruction manual consists
of two chapters. In the first part (chapter 1) you will find instructions on how to use the
devices in the baby monitor mode; the second section provides information on how to use
your device as a transmitter (a normal PMR 446 hand-held radio) that you or your children
may later want to use.
28
Chapter 1: Use in „baby monitor" operating mode
Cable microphone
For use as a baby monitor, an external microphone also forms part of the package. Using
this cable microphone has the following advantages: it is more sensitive than the built-in
microphone and can capture sounds from a greater distance. In this way you can extend
the distance between the child unit and the baby's bed. This greatly reduces radiation in the
child's proximity. In addition, you can place the child unit in such a way as to achieve the
best possible reach - for example, on the bedside or a cupboard.
BLACK
RED
Warning: If you use Care&Talk as a baby monitor, always connect the cable microphone.
Installation of child unit
Attach the supplied cable microphone near the baby's bed, but out of reach of your child. To
secure the microphone securely use the supplied adhesive tape and then secure the cable
with the supplied cable clips and cable guides. Open
the rubber cover for connectiong accessories (MIC/
EAR connector) on the right side of the device, and
plug the male cable microphone connector into the
top female connector.
Standard settings
Turn on the devices by pressing the power switch for
about 3 seconds. Check standard settings. You will find
precise information about each setting in the next chapter.
Child unit (star motif):
• Baby mode:
• Channel: 01b
• Sensitivity control: VOX
• Talk Back function: OFF
Parent unit:
• Parental mode:
• Channel: 01P
• Range control:
29