Setup And Operation; Initial Setup - Medivators ENDO stratus EGA-500 Manual De Instrucciones

VIII. Setup And Operation

Initial Setup

1. Before beginning, inspect the ENDO STRATUS® irrigation pump for any signs of damage.
2. Install the pump head onto the device by aligning the flat shaft on the front of the device with the slotted hole in
the pump head and rotate the pump head until it locks in place.
3. Assemble the water bottle holder and warmer assembly in the following manner:
A. The following supplies are necessary and can be found in a bag attached to the water bottle holder:
a.) Short Screws (2)
b.) Long Screws (2)
c.) Large Hex Key
d.) Small Hex Key
B. Attach the water bottle holder to the base tray using the (2) small screws and small hex key.
C. Place the ENDO STRATUS irrigation pump on the base tray and install the (2) long screws using the
large hex key.
D. Adjust the water bottle hold-down bracket to fit the water bottles used by your facility. This is done by
loosening the nut on the back and sliding the bracket up or down so it contacts the water bottle and
then re-tightening the nut.
EN - 11
IFU-51 / REV G