Tabla de contenido
Idiomas disponibles
Idiomas disponibles
16 | ORBEA
0 4 U SE WAR N I N G S.
RISE H Y DRO
M AXI MUM TY RE WI DT H
However, the real measurements of the tyre circumfer-
ence and width may change from one manufacturer to
mounted on your Orbea bicycle, check that there is at
least 6 mm between the top and the sides of the tyre and
Damage to the frame or components due to
the use of a tyre that does not comply with
these measurements is not covered by the
MINIMUM SEATPOST INSERTION
the minimum insertion depth of the seatpost
or the frame on road bicycles with exclusive
instructions can cause stresses on the ma-
terials beyond the conditions for which they
were designed and cause damage not cov-
ered by the warranty conditions, as well as
M AXI MUM FOR K LEN GT H
(AXL E TO CR OWN )
Always abide by the maximum fork length listed in the
imum fork length refers to the distance between the fork
TECHNICAL MANUAL
The failure to abide by this measurement and
install forks with a length greater than the
beyond its design characteristics, possibly
resulting in malfunctions of the material that
L
MAXIMUM NUMBER OF HEADSET
SPACERS
Never use more headset spacers below the
maximum number of headset spacers that
Installing more spacers than those permitted
-
can stress the materials beyond the use for
which they were designed, which can cause
B LUE PAPER RIS E · H YD RO 2022
P OSITIO N OF TH E STA R NUT INSIDE
THE STEERER TUBE. HEADSET
SPACERS ABOVE THE STEM
O.K.
NOT O.K.
Placing spacers above the stem, especially on
forks with a carbon steerer tube, can cause
the expander inside the fork tube to be po-
sitioned above the lower limit of the steerer
tube, which can stress the materials beyond
the use for which they were designed, pos-
The length of the fork steerer tube must
always be appropriate for the position of the
-
installed in the steerer tube of the fork so that
both fastening bolts on the back of the stem
are positioned above the surface of the stee-
so that the top fastening bolt of the stem re-
mains above the top edge of the fork steerer
the use for which they were designed, pos-
INT ENDED USE
The intended use of all models is ASTM Condition 4, that
includes Condition 1, 2 and 3 as well as technical natural
trails with greater negative gradient and therefore greater
dels, given the terrain they are used on, must be inspected
O.K.
The use of a bicycle on this terrain requires technical skills
For information about all ASTM categories, consult the Ge-
NOT O.K.
ORBEA | 17
EN
-
Capítulos
Tabla de contenido
