Range Extender Assembly; Connecting The Range Extender To Rise Hydro - Orbea BLUE PAPER RISE Manual Tecnico

86 | ORBEA

RANGE EXTENDER ASSEMBLY

Install the Range Extender dedicated mount onto the
When installing the Range Extender holder, remove the
four washers pre-installed on the frame and make sure
that, once installed, the Range Extender´s six contact
3
5 N.m
TECHNICAL MANUAL
x6
Install the Range Extender into the mount and secure it
The Range Extender bottle holder is compatible
with standard bottles when the Range Extender is
not installed.
B LUE PAP ER R I SE · HYDRO 2022
CONNECTING THE RANGE EXTENDER
TO RISE HYDRO
Turn the safety tabs of the Range Extender cable coun-
Open the bicycle charging port and connect the Range
Turn the cable´s safety tabs clockwise to lock the cable
To disconnect the Range Extender cable or to remove the
the cable´s safety tabs and carefully pull from the cable´s
ORBEA | 87
E N
If Rise was On when connecting the Range
Extender to the bicycle, the system will turn
itself Off and you will need to turn Rise On
This happens so the system can reboot and
recognize the Range Extender as part of the
If you were recording an activity with Garmin
Connect using Orbea RS Toolbox, this will
have no effect on the data recorded in the
Once you turn Rise on, the Range Extender
If the Range Extender is disconnected when
the bicycle is On, the bicycle will turn itself
Off and it will be necessary to turn the bicy-
reboot and recognize the internal battery as