Maxon 298905-01 Manual Del Usuario página 24

LIFT CORPORATION Sht. 24 of 58 DSG#
2. In the truck cab, remove the nut
holding the cab switch to dash
panel (FIG. 24-1). Then pull the
switch, plate and wiring from the
dash to gain access to the wiring.
3. Cut RED wire to a length that will
prevent strain on the wires being
connected. Strip insulation from
the RED wire wire to a install 16-14
gauge male bullet terminal (Kit item,
P/N 905288). Then, crimp the male
bullet (Kit item) on the RED wire
(FIG. 24-2).
© MAXON Lift Corp. 2020
CAB SWITCH WIRING DIAGRAM FOR NEW GPSLRT
M-19-05
ON/OFF
PLATE
13/16"
HOLE
ROCKER
SWITCH
DASH
PANEL
REMOVING SWITCH FROM DASH PANEL
FIG. 24-1
FIG. 24-2
Rev. A Date: 10/14/20
WIRES
SWITCH
NUT