Using The Infant Carrier With The Base; Attaching Infant Carrier To Base; Releasing Infant Carrier From Base - CYBEX ATON 2 Manual Del Propietário

Attaching Infant Carrier to Base

1. Make sure handle is LOCKED in the DRIVE/CARRY position.
2. Lift Infant Carrier by the Handle and slide the Attachment
Rod under the Attachment Catch on the Base.
3. Rotate foot end of the Infant Carrier down onto
the Base until an audible
The GREEN Safety Button will pop out from the middle of the Infant
Carrier Release to indicate proper attachment.
The Aton 2 is allowed to touch the vehicle seat(s) in front of it, as long
the recline angle of the Aton 2 is not affected.
WARNING!: To avoid DEATH or SERIOUS INJURY, ALWAYS have the
handle LOCKED in the upright DRIVE/CARRY position while using this
child restraint in a vehicle.

Releasing Infant Carrier from Base

If used, lower the LSP device. See page 39.
1. Press GREEN Safety Button
the Infant Carrier Release down
2. Slightly tilt Infant Carrier toward front of vehicle. Grasp
Infant Carrier with both hands to lift off.
WARNING!: ALWAYS verify that the handle is LOCKED in the CARRY
position before lifting Infant Carrier by the handle. An unlocked handle
could move unexpectedly, causing child to fall out.
38

Using the Infant Carrier with the Base

is heard.
a
in while pushing
b .
1
1
a
b
2
2