Securing The Child - CYBEX ATON 2 Manual Del Propietário

Securing the Child

1. Loosen Harness by firmly pressing down the Harness Adjustment
a
Button while pulling forward on both straps at shoulder level.
2. Press RED button on Harness Buckle to release Tongues.
3. Separate Chest Clip and spread straps apart. Place child in
Infant Carrier in seated position making sure their bottom
is in the seat, and their back is fully supported.
4. Pull Harness straps over each arm onto shoulders and around the hips.
Make sure Buckle Pad and Harness Buckle are between the legs.
Newborns tend to draw arms and legs close to their bodies. Gently extend
each limb to allow for proper Harness positioning. Be mindful of especially
sensitive areas.
5. Buckle by inserting one Tongue at a time into the
Harness Buckle listening for an audible
one. Make sure Harness Straps are not twisted.
WARNING!
• MAKE SURE Harness straps are AT or BELOW child's shoulders. If not, refer
to Adjusting Harness Height on page 18, or the Infant Insert section found
on page 19.
• ALWAYS check Harness Buckle to make sure it is securely latched..
6. Connect the Chest Clip listening for an audible
20
Using the Infant Carrier
b
with each
DEATH or SERIOUS
INJURY can occur
.
1
b
a
4
6
3
2
5