Open Windows Function - Cointra Cosmos Instrucciones De Instalación

It allows the user to manually operate the emitter and override the current setting. It is able to force
the emitter to heat or to not for a set amount of time. After the time expires, the emitter will return
to the previous mode of operation.
To enter Manual mode, touch the suitcase key and then use the p and q keys
to enter the amount of time you want to force the emitter to heat or not.
First the number of days is selected; enter between 0 and 365 days and
confirm using the OK key. If you only want a few hours, touch OK to enter
0 days.
The menu the moves to the number of hours selection. The user is able to enter the amount of
time to operate in 1 minute increments up to 1 hour, after which time the steps increase to 30
minutes increments.
When the total desired time is entered, confirm with the OK key.
Please note the default minimum time is 30 minutes, however this can be decreased using
the q key.
Finally, the desired temperature can be set by the p and q
keys; any temperature between 7 °C and 30 °C (in steps of
0.5 °C) can be entered. Unheated mode can be entered from
either 7 °C or 30 °C by touching the q or p keys once from
each extreme. Unheated mode is displayed with 4 dashes on
the screen (- - - -). When the desired temperature is entered
confirm with the OK key. The screen will display "DONE".
If no key is touched within 30 seconds before final confirmation, or the Mode key is touched, the
emitter will return to the previous mode of operation.
The selected time will remain on the display and count down until it is finished.
Although the set time cannot be changed, it is possible to change the set point
temperature during the operation of Manual mode.
Once the set time has elapsed, the emitter will automatically return to the previ-
ous mode of operation.
To exit Manual mode at any time, touch the Mode key and the emitter will return
to the previous mode of operation.
In the case where the power is disconnected to the emitter, the Manual mode settings will be
saved and the remaining time will count down even though the emitter is powered-off.

5.7 OPEN WINDOWS FUNCTION

When the Open Windows function is enabled in the configuration menu the emit-
ter automatically stops heating when it detects a sudden drop in the temperature
(4 °C in 20 minutes). This is normally caused when a window or door is opened
to the outside without turning off the emitter.
When the Open Windows function has been activated, it will be shown on the display by a single
screen with an open window.
94
EN A73023080