Risk Of Burns; Welding Process; Removal From Service - Abicor Binzel AUTC 61GD Instructivo De Servicio

MAG

7.1 Welding process

8 Removal from service

DANGER

Risk of burns

During welding work spraying sparks, glowing work-pieces or hot slag can
produce flames.
• Check work area for seats of fire.
• Make suitable fire extinguishing materials available at the workplace.
• Allow work-pieces to cool down after welding.
• Prior to performing welding work, fasten the ground clamp properly to
the work-piece or the welding table.
WARNING
Arc burn of the eyes
The arc produced by welding may damage the eyes.
• Wear protective clothing and eye protection.
NOTE
• The MAG may only be operated by qualified personnel.
• As the MAG is integrated into a welding system, the operating
instructions of the welding components, such as welding torch and power
supply, must be observed during operation.
• For MAG welding, ensure that all the parameters are set at the power
supply for your welding task.
1 Open the shielding gas cylinder.
2 Switch on the power supply
3 Setting the welding parameters
1 Wait until the shielding gas flow has subsided.
2 Switch off power supply.
3 Close the valve of the shielding gas cylinder.
8 Removal from service
EN - 13