Functional Description; Risk Of Fire - Abicor Binzel FES-200 Instructivo De Servicio

FES-200

5 Functional description

DANGER

Risk of fire

Before installing and operating the fume extraction system, please observe the following:
• The extraction of welding fume during welding of oil-wetted parts is not allowed.
• It is not allowed to install or operate the system in areas subject to dust or gas explosion hazards.
CAUTION
• Before putting into operation, it must be checked if the operating voltage given on the nameplate corresponds to the
mains voltage.
NOTICE
• Use the fume extraction system FES-200 only in areas with sufficient ventilation.
• The device is equipped with a safety device to monitor the minimum air volume flow to be extracted. A manometer is
used for monitoring. The point at which the minimum volume flow is reached is marked on the dial scale. If the
manometer indicates a higher vacuum (>180mbar), the filter must be cleaned.
Harmful fumes are produced during the welding process. This welding fume can be captured and filtered by an extraction
torch with welding fume filter. The filtered air is led back to the work area.
The FES-200 captures the welding fume with high vacuum directly on the source. Thanks to the permanent filter cartridge that
can be cleaned, the particles are collected in the dust collecting drawer and can then be emptied and eliminated in the dust
collecting bag.
The FES-200 can be equipped with an automatic Start-Stop system. Use the start-stop pliers to switch on automatically the
fume extraction system by fixing it to the cable assembly of the welding device.
The rocker switch (2) is used to switch the device on and off.
 7 Operation on page EN-17
BAL.0209.0 • 2019-08-06
5 Functional description
EN - 11