Function And Operation - RS Pro RS HS-608 Manual De Instrucciones

Oscilloscope Section/English
•To avoid electric shock, don't touch the metallic part of the probe top while connecting to
voltage source.
•Measured signal by the oscilloscope is taken as a reference voltage to the ground, make sure
the ground terminal connect to the earth correctly, do not cause a short circuit.
1-3-2 Probe application
1. Connect the oscilloscope probe with the connector, and insert into the input terminal of the
device.
2. If use probe hooked head, make sure the hook end firmly attached to the probe.
3. Probe connection mode must be selected while the measuring frequency of the signal is
above 1 Khz.

2.Function and Operation

In order to operate the oscilloscope efficiently, user needs to know the following
functions:
•Interface and buttons
•Connector and probe
•Settings of system
•Vertical system
•Horizontal system
•Trigger system
•Signal capture system
•Display system
•Measuring system
•Memory system
•Auxiliary system
•Online help system
2-1 Interface and Buttons
See the following picture:
Picture 2-1
•Please follow the prompts of display interface for the use
of F1-F4.
•HOLD hold key (freezes all the readings in the display)
•MODE function key switch (switch the cursor and waveform
position)
•AUTO auto search key (search waveform of unknown
frequency or amplitude)
•REC record key (record current waveform content, the length is 10 pages)
• direction key (adjust sample rate, preselecting amplitude and etc.)
35 13/08/2017 Version No. 001
2 2 Connector -
•The probe and connector must be used when the measuring frequecies above 1KHz.
•When measured waveform signal of DC or measuring frequency is below 1KHZ, the
stick of general oscilloscope can be adopted.
•If the device is isolated, no need to differentiate phase line or null line when measuring
industrial frequency voltage.
2-3 Help Section
For the convenience of user, built-in simple instructions in Digital Oscilloscope is available,
part one presents the function of various function keys, part two indicates quick start use.
•Press F1 (HELP), enter into help section
•Press F4, quit from help section
2-4 System Settings
1. Digital Oscilloscope can adjust relative trigger mode according to input signal.
2. Setup the coupling mode according to input signal.
3. Setup the warning tone is activated or not.
Chart 2.4.1
Function observations
Trigger mode Rising edge, falling edge, no trigger
Coupling mode AC coupling, DC coupling
Warning tone Key tone, no key tone
Set up by taking the following steps:
1.Running state (RUN), press F2 according to the
prompt (SET), enter into setup interface(SYSTEM SETUP).
2.Press " " by user's needs to select the function
in chart 2.4.1
3.Press " " by user's needs to select the observation
in chart 2.4.1
4.Press F4, save the settings and quit, see picture 2-4-1.
13/08/2017 Version No. 001
Oscilloscope Section/English
Picture2-4-1
37