RS Pro RS HS-608 Manual De Instrucciones página 6

MeterScope/English
5-3.Making dB Measurements
The Meter is capable of displaying voltage as a dB value, either relative to 1 milliwatt (dBm),
a reference voltage of 1 volt (dBV) or a user-selectable reference value.
1.Set the function switch to the green VAC position.
2.press the softkey labeled Menu. Move the menu selector to
the menu item labeled dBm. Press the softkey dBm
3.Insert the black test lead banana plug into the negative COM
jack. Insert red test lead banana plug into the positive V jack.
4.Read the voltage in the main display and the dBm in the
Secondary display
5.To select another reference value, press the softkey labeled Ref to display a message box
with the current reference value. Pressing
references: 4,8,16,25,32,50,75,600 and 1000. Set the reference by pressing the softkey labeled
OK.
5-4.Low Pass Filter
The Meter is equipped with an ac low pass filter. When
measuring ac voltage, press the soft key labeled Menu to
open the function menu, and move the menu selector to the LO
item. Next, press the softkey labeled LO totoggle the low pass
filter mode .
8
or , scrolls through the nine predefined
13/08/2017 Version No. 001
5-5.mV Voltage Measurements
CAUTION: Do not measure mV voltages if a motor on the circuit is being switched ON or
OFF. Large voltage surges may occur that can damage the meter.
1.Set the function switch to the green mV
position.
2.Press the soft key labeled Menu.
Move the menu selector to the menu item
labeled mVDC(mVAC). Press the soft key
mVDC(mVAC).
3.Insert the black test lead banana plug into
the negative COM jack. Insert the red test
lead banana plug into the positive V jack.
4.Read the mV voltage in the display
13/08/2017 Version No. 001
MeterScope/English
9