RS Pro RS HS-608 Manual De Instrucciones página 3

MeterScope/English
OVERVOLTAGE CATEGORY II
Equipment of OVERVOLTAGE CATEGORY II is energy-consuming equipment to be supplied
from the fixed installation.
Note – Examples include household, office, and laboratory appliances.
OVERVOLTAGE CATEGORY III
Equipment of OVERVOLTAGE CATEGORY III is equipment in fixed installations.
Note – Examples include switches in the fixed installation and some equipment for industrial
use with permanent connection to the fixed installation.
OVERVOLTAGE CATEGORY IV
Equipment of OVERVOLTAGE CATEGORY IV is for use at the origin of the installation.
Note – Examples include electricity meters and primary over-current protection equipment
3.Safety Instructions
This meter has been designed for safe use, but must be operated with caution.
The rules listed below must be carefully followed for safe operation.
3-1.NEVER apply voltage or current to the meter that exceeds the specified maximum:
Input Protection Limits
Function
V DC or V AC
mA AC/DC
A AC/DC
Frequency, Resistance, Capacitance,
Duty Cycle, Diode Test, Continuity
Temperature
Surge Protection: 8kV peak per IEC 61010
3-2.USE EXTREME CAUTION when working with high voltages.
3-3.DO NOT measure voltage if the voltage on the "COM" input jack exceeds 1000V above
earth ground.
3-4.NEVER connect the meter leads across a voltage source while the function switch is
in the current, resistance, or diode mode. Doing so can damage the meter.
3-5.ALWAYS discharge filter capacitors in power supplies and disconnect the power when
making resistance or diode tests.
3-6.ALWAYS turn off the power and disconnect the test leads before opening the covers to
replace the fuse or batteries.
2
Maximum Input
1000VDC/AC RMS
800mA 1000V fast acting fuse
10A 1000V fast acting fuse
(20A for 30 seconds max every
15 minutes)
1000VDC/AC rms
1000VDC/AC rms
13/08/2017 Version No. 001
3-7.NEVER operate the meter unless the back cover and the battery and fuse covers are in
place and fastened securely.
If the equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
4.Feature
4-1.Understanding the Push Buttons
The 12 push buttons on the front of the Meter activate features that
augment the function selected using the rotary switch, navigate
menus or control power to Meter circuits.
F1F2F3F4 Selects sub-functions and modes related to the rotary switch function.
Cursor buttons select an item in a menu, adjust display contrast, scroll through information,
and perform data entry.
HOLD Freezes the present reading in the display and allows the display to be saved. Also
accesses AutoHold.
RANGES switches the Meter range mode to manual and then cycles through all ranges. To return
to auto ranging, press the button for 1 second.
MAX/MIN Starts and stops MIN MAX recording.
ESC Return from Power off
.
13/08/2017 Version No. 001
MeterScope/English
HELP
RANGE
HOLD AUTO
ESC
MODE REC
3