Function And Response Table; Step 4: Adjust The Pet Area To Desired Size - Petsafe Stay & Play PIF19-17106 Manual Del Producto

Tabla de contenido

Idiomas disponibles

Set the Static Stimulation Level

Read all steps before attempting to set the static stimulation level.

1. Press the mode button and release (3B) when the receiver indicator light illuminates red (3C).

2. The receiver indicator light will emit a series of red flashes representing the static stimulation level.

3. Increase the static stimulation level by pressing and releasing the mode button within 5 seconds of the previous series of flashes.

The static stimulation levels increase in strength from 1 to 6. Pushing the stimulation level button while the receiver collar is on Level 6 will cause

the receiver collar to revert to Level 1. Refer to the function and response table to choose the static stimulation level that best fits your pet.

Indicator Light Response

1 Red Flash

2 Red Flashes

3 Red Flashes

4 Red Flashes

5 Red Flashes

6 Red Flashes

Over-Stimulation Protection

If your pet enters the boundary zone or continues anywhere beyond the pet area, this feature limits the static stimulation duration to 15 seconds.

While the system locks out further static stimulation, the green light will remain on for 10 seconds.

In the unlikely event that your pet leaves the pet area, he will not receive static stimulation upon return to the pet area.

Step 4: Adjust the Pet Area to Desired Size

Make sure the entire pet area lies within your property boundaries (4A). Always start determining the boundary zone at the shortest distance

from the transmitter. Place the boundary switch on "–" if the boundary zone will be less than 13.5 m from the transmitter.

Note: If your next-door neighbour has a containment system, see Troubleshooting section page 15.

Test Light Instructions

1. Make sure the receiver collar battery is correctly charged.

2. Set the stimulation level to 2 or above.

3. Hold the test light contacts to the contact points (4B).

4. Walk towards the boundary zone holding the receiver collar around waist height until the test light flashes (4C).

Save test light for future testing.

To maximise your pet area, make sure the boundary switch is on "+" and the boundary control dial is set to "8". Plug power adaptor into power

jack and standard outlet. Turn the transmitter on.