Step 2: Charge The Receiver Collar; Step 3: Prepare The Receiver Collar - Petsafe Stay & Play PIF19-17106 Manual Del Producto

Step 2: Charge the Receiver Collar

Receiver
Indicator
Light
The receiver collar charger is designed to plug into a standard AC wall outlet. The receiver collar light will glow red when the receiver charger
is correctly seated in the receiver charge jack. The light will turn green when charging is complete. A built-in safety circuit prevents the receiver
collar from overcharging.
The receiver collar will reach full charge within 2-3 hours. Each charge can last up to 3 weeks, depending upon frequency of use.
Do not charge your receiver collar every night. Frequent charging can have a negative effect on the battery.
We recommend that the receiver collar be used until the receiver indicator light blinks yellow or red.
Charge the Receiver Collar
Lift and slide the receiver collar strap away from the front of the unit (2A). Lift the rubber plug to allow access to the receiver charge jack.
The rubber plug needs to remain attached to the receiver collar. Plug the receiver charger into the receiver charge jack on the receiver collar.
The receiver charge jack and receiver charger are keyed to fit one way. Do not force it in backwards.
2A

Step 3: Prepare the Receiver Collar

Your receiver collar comes with short contact points. Use the long contact points for pets with long or thick hair. Tighten the contact points using
the contact point wrench (3A). Check tightness weekly.
Turn the Receiver Collar ON
Press and hold the mode button continuously for 5 seconds (3B). The green or yellow or red receiver indicator light will turn ON for 5 seconds
(3C) to indicate battery status, followed by the red receiver indicator light flashing the static stimulation level settings.
Turn the Receiver Collar OFF
Press and hold the mode button continuously for 5 seconds. The red receiver indicator light will be ON during this time. The red receiver
indicator light will then turn OFF and all receiver indicator lights will stay OFF indicating that the unit is turned OFF.
To extend the time between charging the receiver collar, consider turning OFF the receiver collar when it is not in use.
3A
8
Mode
Contact
Button
Point
3B
Mode
Button
petsafe.com
Receiver
Charge
Jack
3C