Re-Thread The Collar - Petsafe Stay & Play PIF19-17106 Manual Del Producto

To assure a correct fit, please follow these steps:
1. Make sure the transmitter is not plugged in and the receiver collar is turned off.
2. Start with your pet standing comfortably (6A).
3. To make it easier to hear the warning beep, place the receiver collar on your pet with the logo side
of the receiver facing your pet's chin.
4. Centre the contact points underneath your pet's neck, touching the skin.
You may need to trim your pet's hair in the area of the contact points.
Never shave your dog's neck; this may lead to a rash or infection.
5. Check the tightness of the receiver collar by inserting one finger between the end of a contact point
and your pet's neck. The fit should be snug but not constricting (6B).
a. Allow your pet to wear the collar for several minutes then re-check the fit.
b. Check the fit again as your pet becomes more comfortable with the receiver collar.
6. Trim the collar as follows (6C):
a. Mark the desired length of the receiver collar with a pen. Allow for growth if your pet is young or grows a thick winter coat.
b. Remove the receiver collar from your pet and cut off the excess.
c. Before placing the receiver collar back onto your pet, seal the edge of the cut collar by applying a flame along the frayed edge.
6B

Re-Thread the Collar

Ridges
Slide
Buckle
6C
Slide
Buckle
The slide buckle prevents the collar from
becoming loose around your pet's neck.
The ridges must be facing up; the collar will
slip if it is not correctly threaded.
To loosen: Slide the strap through the
Fasten
Slide and Fasten Buckles and pull down.
Buckle
To tighten: Slide the strap up through the Fasten
Buckle and pull through the Slide Buckle.
petsafe.com
6A
13