Setting Up The Camera Head - Stryker 1288010000 Manual Del Usuario

Note: If you are using any device with unterminated analog video inputs, you must connect a cable
from the VIDEO OUT of that device to the VIDEO IN on the monitor.
Note: An additional monitor may be connected using an open camera output.
Note: The camera console is shipped from the factory in NTSC video format. If necessary, the video
format can be changed to PAL by using the "Options" submenu in the configuration menu. See the
"Using the Configuration Menu" section of this manual.
1. Power on the monitor.
2. Power on the camera.
Note: A color bar pattern will appear on the monitor when the camera head is not connected to the
camera console. Follow the instructions in the "Setting Up the Camera Head" section of this manual
to connect the camera head to the console.

Setting Up the Camera Head

Caution Do not severely bend the camera cable or damage may result.
Note: To unplug the camera from the control unit, grasp the knobbed portion of the connector and
pull straight out.
1. Connect the camera head to the console.
• Unscrew the soaking cap from the cable connector if necessary.
• Align the blue arrow on the cable connector with the blue arrow on the camera-
connector port on the front console panel.
• Push in the connector until it locks in place.
17