End Of Day; Weekly; Monthly - Alliance Laundry Systems UW35PV Instalación/Mantenimiento

Maintenance
Daily
(Continued)

End of Day

1. Clean the AC drive filter:
a. Snap off the external plastic cover
which contains the filter.
b. Remove the foam filter from the cover.
c. Wash the filter with warm water and
allow to air dry. Filter can be vacuumed
clean.
2. Clean the door gasket of residual detergent
and all foreign matter.
3. Clean automatic supply dispenser and lid
inside and out with mild detergent. Rinse
with clean water.
4. Clean powder dispenser and lid with mild
detergent. Rinse with clean water.
5. Clean washer's top, front, and side panels
with mild detergent. Rinse with clean
water.
6. Leave loading door open at the end of each
day to allow moisture to evaporate.
7. If the washer-extractor is equipped with
the Premium Wet Clean Module, clean the
water recirculation filter, located in the
canister, of all debris.
Note: Unload the washer-extractor promptly
after each completed cycle to prevent moisture
buildup. Leave loading door open at the end of
each completed cycle to allow moisture to
evaporate.
44 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Weekly

1. Check the washer-extractor for leaks.
a. Start an unloaded cycle to fill the
washer-extractor.
b. Verify that door and door gasket do not
leak.
c. Verify that the drain valve is operating
and that the drain system is free from
obstruction. If water does not leak out
during the prewash segment, drain
valve is closed and functioning
properly.

Monthly

Note: Disconnect power to the washer-
extractor at its source before performing the
monthly maintenance procedures.
1. Each month OR after every 200 hours of
operation, lubricate bearings. (Locate the
bearing lubrication decal at the rear of the
right side of the machine, as viewed from
the front of the washer-extractor.)
The grease must have the following
characteristics:
• NLGI Grade 2
• Lithium-based
• Water-insoluble
• Anti-rusting
• Anti-oxidizing
• Mechanically stable
F232084