Alliance Laundry Systems UW35PV Instalación/Mantenimiento página 29

To connect water service to machine with
rubber hoses, use the following procedure:
1. Before installing hoses, flush the water
system for at least two minutes.
2. Check filters in the washer-extractor's
inlet hoses for proper fit and cleanliness
before connecting.
3. Hang the hoses in a large loop; do not
allow them to kink.
If additional hose lengths are needed, use
flexible hoses with screen filters. Each hose
should have a screen filter installed to keep
rust and other foreign particles out of the water
inlet valves.
Pressure of 30 – 85 psi (2 – 5.7 bar) provides
best performance. Although the washer-
extractor will function properly at lower
pressures, increased fill times will occur.
Suitable air cushions should be installed in
supply lines to prevent "hammering." (See
Figure 9.) If the water pressure is above 60 psi,
flexible copper tubing should be used in place
of rubber hoses.
For machines labelled with the CE mark,
backspiphon protection devices must be
installed previous of all machine water inlet
valves in accordance with accepted European
standards.
F232084 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
Water Supply
Faucets
Figure 9
UWPV Pocket Hardmount
Water Supply Line Sizing
Supply Line Size, in (mm)
Number
of Machines
1
2 1-1/2 (38)
35
3
4
1 1-1/4 (32)
2
60
3
4 2-1/2 (64)
1 1-1/4 (32)
2
80
3
4 2-1/2 (64)
1 1-1/2 (38)
2
100
3
4 2-1/2 (64)
1
2 2-1/2 (64)
125
3 2-1/2 (64)
4 2-1/2 (64)
Air Cushions
(Risers)
P038IE3A
Main Hot/Cold
1 (25) 3/4 (19)
1 (25)
2 (50) 1-1/4 (32)
2 (50) 1-1/2 (38)
1 (25)
2 (50) 1-1/4 (32)
2 (50) 1-1/2 (38)
2 (50)
1 (25)
2 (50) 1-1/4 (32)
2 (50) 1-1/2 (38)
2 (50)
1 (25)
2 (50) 1-1/2 (38)
2 (50) 1-1/2 (38)
2 (50)
2 (50) 1-1/4 (32)
2 (50)
2 (50)
2-1/2 (64)
27