Stryker SIDNE Visum Guia Del Usuario página 11

3. Follow the voice instructions given by SIDNE. To avoid equipment damage,
please do not remove the dongle card before SIDNE® says, "Please remove
card. " After installation is complete, SIDNE® will power off.
When SIDNE says this...
"Software card detected. Please stand by. "
"Software installation started. Please wait. "
"Programming started. "
"10% complete, 20% complete... "
"Programming failed. "
"Programming complete. Please wait. "
"Software installation complete. "
"Please remove card. "
4. Power SIDNE on. When SIDNE says, "SIDNE ready, " the driver is installed
and ready for use.
Do this...
Wait for the next instruction.
Do not remove the dongle until
SIDNE says, "Please remove card. "
Wait for the next instruction.
Wait for the next instruction.
SIDNE will announce this message
only if the programming failed. If
this occurs, follow the steps below:
1. Remove the dongle,
restart SIDNE, and
insert the dongle.
2. If the same problem
occurs again, contact
Stryker Technical
Support.
Wait for the next instruction.
Wait for the next instruction.
Remove the dongle.
11