Setup And Interconnection; Quick Startup Guide; Installing Driver Upgrade - Stryker SIDNE Visum Guia Del Usuario

Setup and Interconnection

Quick Startup Guide

This section outlines the startup instructions for experienced users. Refer to the
relevant section(s) of this manual for further details.
1. Power on the SIDNE® console.
2. Install the Visum™ LED Surgical Light and Camera Driver 1.0 upgrade.
SIDNE will power off.
3. Power on SIDNE. Wait for SIDNE to say, "SIDNE ready" before connecting
the Visum LED Light and Camera.
• Connect the device adapter cable to the Visum LED Light and Camera.
• Connect the SIDNE interface cable to SIDNE.
4. Power on the Visum LED Light and Camera. SIDNE should say, "O.R.
Lights connected. "

Installing Driver Upgrade

The SIDNE Visum™ LED Surgical Light and Camera Driver Upgrade 1.0 allows
the SIDNE console to communicate with the Visum LED Light and Camera.
Caution
Caution
1. Power on the SIDNE console and wait until SIDNE says, "SIDNE ready. "
2. Insert the dongle into the device-driver dongle port on the front SIDNE
panel (see below).
10
Read the Operational Notes at the end of this procedure
before using the SIDNE console to control the Visum LED
Light and Camera.
Do not attempt to install any other software driver until the
installation of the Visum™ LED Surgical Light and Camera
Driver is complete and the SIDNE console has restarted.