Automatic Mode - Sima DEL-32 Manual De Instrucciones

13.1 AUTOMATIC MODE.

To Access this mode, select the position AUTO in the machine front panel switch and then go to the screen of
the application and press the following icon (Auto):
On automatic mode, keep the screen always visible to have information of the angle and the
programmed bending sequence. Keep it in a safe place to avoid the device suffering damage or
interfering in the user work. Make sure at the start that only the operator is setting changes in the
application.
In the case that the operation mode selector on the machine front panel is on the "Manual" position, the
following warning message will come up on the screen:
Check the operation mode selector position (manual or automatic) before starting the bending
operations.
When the front panel switch is on the "AUTO" position, the following menu will come up on the screen:
22
ENGLISH