Making A Cut - Sima DEL-32 Manual De Instrucciones

4. Step on the pedal and don´t lift off. The bending plate will move until the pin reaches the inversion switch.
5. To make the plate return lift your foot off the pedal and press again and the plate will return.
The DEL and COMBI TRONIC models, in addition to being able to perform the bending by means of the plate
pin, it is possible to carry it out automatically. To do this, simply access the automatic mode in the application (explained
later) and program the desired bending angles.

10. MAKING A CUT.

To use the machine as a shear, do the following:
WARNING: Remove all the bolts, shells and pivots that are on the bending plate.
WARNING: Never use the machine for cutting and bending at the same time as this presents a
great risk to accidents and an over effort for the motor and the reducer causing serious damages.
CONTINUOUS CUTTING.
Remove all the bolts, shells and pivots that are on the bending plate and press the pedal.
MODO CORTE A CORTE.
To obtain a cutting in cycles, you can prepare the machine, placing an inversion pivot "P" right in the interior, small
hole in the end of course of the plate exactly when the blades close.
14
P
ENGLISH