Adjusting The Bending Angle; Making A Bend - Sima DEL-32 Manual De Instrucciones

8.1 ADJUSTING THE BENDING ANGLE.

If you haven´t achieved the bending angle you require with the pin and you need to make a small adjustment
you can use the silver metal handles on the side of the machine to move the support mandrels. Turn the handle to push
the mandrel further away to make a tighter angle and bring it towards to make a more open angle.
The DEL TRONIC and COMBI TRONIC models allow calibration by using the rule knobs and by tapping the
desired correcting angle when operating in automatic mode.

9. MAKING A BEND.

Before starting to bend a rebar make some bends without any accessories on the machine until you are
comfortable with the movement.
1. Divide the bending plate into 4 imaginary 90º sections.
2. Select bending direction with the control panel button.
3. Insert the plate pin to the left of 0º so achieve an angle of 90 º.
13
ENGLISH