Sequence Of Operation; Operasjonsrekkefølge - ESAB ESP-400C Manual De Instrucciones

kapIttel 4
4.3 funksjonsrekkefølge
SECTION 4

4.3 Sequence of Operation

PILOT
ARC
4.4 Arc Initiation Settings
Apply Power
PANEL
REMOTE
HIGH
LOW
ACTUAL AMPS
PRESET AMPS
Begin
Cutting
1. Apply power by closing the line (wall) switch.
1. Tilkople nettstrøm ved å sette den eksterne skillebryteren til
(The ESP-400C does not have an on/off
PÅ. (ESP-400C har ingen AV/PÅ-bryter). Nettspenningsindika-
switch). The main power light will illuminate
toren MAIN POWER vil lyse, og feilindikatoren FAULT vil blunke
and the fault light will flash and then go out.
for deretter å slukke.
2. Velg innstilling for venderen PANEL/REMOTE.
2. Select the Panel/Remote setting.
3. Still inn venderen PILOT ARC HIGH/LOW. (Se skjæredata i
3. Set pilot arc High/Low switch. (Refer to cutting
brennerhåndboken).
data in the torch manual.)
4. I PANEL-modus, se på forhåndsinnstilt strøm ved hjelp av
4. If using panel mode, view preset amps with the
ACTUAL AMPS / PRESET AMPS-venderen (ACTUAL=virkelig,
PRESET=forhåndsinnstilt). Juster strømmen inntil omtrentlig ACTUAL/PRESET AMPS switch. Adjust current
ønsket verdi vises av amperemeteret. I fjernstyringsmodus,
until the approximate desired value is shown on
hvis ACTUAL AMPS / PRESET AMPS-venderen er satt til PRESET
the ammeter.
AMPS, vises utgangsstrømmen fjernkontrollen vil begynne
5. Begin plasma cutting operation. This may
med.
include manually setting up other options,
5. Start plasmaskjæreoperasjonen. Dette kan inkludere andre
depending on the total plasma package.
manuelle forhåndsinnstillinger, avhengig av den totale
plasmapakken.
6. If using panel mode, after cutting has begun,
6. I PANEL-modus, etter at skjæringen har begynt, juster strøm-
adjust current to desired amount.
men til ønsket verdi.
7. Check for fault light. If a fault light illuminates,
7. Hvis skjæring eller avmerking ikke vil starte opp, sjekk om
refer to troubleshooting section.
feilindikatoren FAULT lyser. Hvis den lyser, se feilsøking-
skapitlet.
Note: The fault light flashes when the contactor is Note: The fault light flashes when the contactor is Note: The fault light flashes when the contactor is Note: The fault light flashes when the contactor is
first turned on signifying the DC Bus powered up first turned on signifying the DC Bus powered up
first turned on signifying the DC Bus powered up first turned on signifying the DC Bus powered up
normally. normally. normally. normally.
merknad:
Feilindikatoren FAULT blinker når kontaktoren skrus
på første gang, noe som betyr at likestrømsbussen
starter opp på normal måte.
The time to achieve full current can be adjusted to
suit your particular system. This feature uses 50%
of the cutting current to start, dwell and then
gradually (less than a second) achieve full current.
The ESP-400C is factory shipped with this feature
enabled. The default settings are:
Minimum Start Current
89
Start Current
Timing to achieve full current
Bruk
Operation
40A
50% of cut current
800 msec