Installation B-Type Adapter; Installation C-Type Adapter; Installation D-Type Adapter - Philips WP3861/01 Manual De Instrucciones

installation B-type adapter
- For taps with an aerator (threaded outside) (Fig. 7).
1 Remove the attachment nut and the adapter from the water
purifier (Fig. 8).
 Remove the aerator cap from the tap and pass the attachment nut
over the spout. Take out the original adapter and screw the
matching adapter (B-type) onto the tap (Fig. 9).
3 Tighten the adapter further with a coin (Fig. 10).
 Firmly screw the attachment nut onto the water purifier
housing (Fig. 11).
installation C-type adapter
- For taps with an aerator (threaded inside) (Fig. 12).
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 13).
 Remove the aerator cap from the tap. Take out the original adapter
and screw the matching adapter (C-type) onto the tap through the
attachment nut. (Fig. 14)
If water leakage occurs, wind Teflon tape round the adapter's thread
before you screw it onto the tap.
3 Tighten the adapter further with a coin (Fig. 15).
 Firmly screw the attachment nut onto the water purifier
housing (Fig. 16).
installation D-type adapter
- For taps other than A, B or C. (Fig. 17)
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 18).
 Take out the original adapter and screw the D-type adapter onto
the water purifier housing. (Fig. 19)
3 Push the water purifier housing onto the tap from below and
tighten the 4 screws evenly (Fig. 20).
English
9