USER INSTRUCTIONS
The new burners called "Series III" are assem-
bled on certain cooker hobs. The lock system
between cover (B) and flame spreading (A)
guarantees perfect positioning and large
cleaning ability.
The upper cover (B) of the burners must be placed in opposite seat with the two intro-
ductions notches in correspondence of the two cylinders below (C) and tighten clock-
wise.
The associated burner is indicated near each knob.
The appliance is equipped with an electric ignition
device. It is sufficient to press the knob and rotate it
anti-clockwise to the maximum flame symbol, until
it is lit. If it does not ignite within the first 15 sec-
onds, bring the knob on
and do not try to re-ignite for 60 seconds.
Once it is lit, keep the knob pressed for a few sec-
onds in order for thermocouple to heat up. It is
possible that the burner shuts off when the knob
is released: this means that the thermocouple was
not sufficiently heated. Wait a few seconds and re-
peat the operation, keeping the knob pressed for a
little longer. Once the burner is lit, it is possible to
adjust the flame based on need.
After every use of the hob, always verify that the
control knobs are in
tion.
If the burners were to shut off accidentally, after
about 20 seconds a safety device intervenes and
blocks gas output, even when the tap is open. In
this case bring the knob to
position and do not try to light the burner for at
least 60 seconds.
36
[chiuso] (closed)
[chiuso] (closed) posi-
[chiuso] (closed)
USER INSTRUCTIONS
Fig. 10: positioning of the series III burner
OFF
MAX
MIN
Fig. 11: standard burner knob
CHIUSO
MAX 1
MAX 2
MAX 1
MIN 2
Fig. 12: burner knob
dual (S4000)/dual gear
CHIUSO
1 MAX
2 CHIUSO
1 MIN
2 CHIUSO
Fig. 13: burner knob
dual (GIOTTO/VULCANO)
1 INSIDE BURNER
2 EXTERNAL CROWNS
MIN 1
CHIUSO 2
MAX 1
CHIUSO 2
1 INSIDE BURNER
2 EXTERNAL CROWNS
1 MIN
2 MIN
1 MAX
2 MAX