Philips HeartStart Instructor OnSite HS1 Manual De Instrucciones página 18

8
pads cartridge requires battery power. The defibrillator battery is designed to
support 10 hours of training use. If battery power is low after training, the
defibrillator will chirp to alert you. Be sure to replace the battery with a new
M5070A battery.
Prepare the training pads cartridge for its next use as follows:
1. Turn off the defibrillator. The following steps can be performed as illustrated
or with the training pads cartridge in the defibrillator.
2. Reapply the pads to each side of the solid
yellow liner, making sure that the red tabs
are positioned at same end of the liner as
the yellow tab (A). Press the pads firmly
together on the liner.
3. Untwist the wires. Then wind the wires
around the defibrillator's cartridge recess, pressing them into the track (B).
Then place the pads over the wound wires in the cartridge. The chest pad
should be on top, and the tab ends of the pads at the curved end of the
cartridge (C). Fold the tab down over the top pad (D).
B
4. Press the resealable film
cover over the cartridge,
with the tab end at the
top (E). Be sure to fold
the tab back down under
the lid (F).
5. Fit the hooks on the
bottom of the clear hard protective lid into the
holes at the bottom edge of the cartridge, and
press the lid down (G). Be sure the cartridge
handle snaps into place. The training cartridge is
now ready for its next use.
A
C
E
D
F
G