Xerox GBC Fusion Punch II Guia Del Usuario página 58

The Finishing Window will display, defaulted to the Finishing tab.
3
Click on the On-line Finishers tab. The window will display as shown
below.
4
Verify that the GBC FusionPunch II profile is Enabled. If this profile
is not visible in this window, go to step 8. If this profile is visible but not
Enabled (green check-mark in the Enabled column), highlight the
profile and click Enable and then click Close.
Starting a Job
Figure 2-11: On-line Finishers tab
On-line
Finishers
Tab
2
2-15