Xerox GBC Fusion Punch II Guia Del Usuario página 51

9
If the holes are centered, go on to Setting the Side Guide. If the holes
are not centered, go on to Step 10 to adjust the Punch.
10
Open the Right Punch Door.
11
Loosen the Locking Wing Nut, as shown in Figure 2-6.
12
Use the Edge Guide Adjustment Knob to make small (1/8 to 1/4-turn)
adjustments, as shown in Figure 2-6. Test after each adjustment until
the punched hole sets are centered.
Locking Wing Nut
13
Tighten the Locking Wing Nut after you have completed the
adjustments.
2-8
Figure 2-6: Edge Guide Adjustment
Edge Guide
Adjustment Knob
General Procedures