Removing And Replacing Die Pins - Xerox GBC Fusion Punch II Guia Del Usuario

Removing and Replacing Die Pins

1
To remove and replace individual die pins, slide the Pressure Bar
release levers to the side and lift the Pressure Bar off of the Die, as
shown in Figure 2-4.
You may now remove and replace individual die pins.
Pressure Bar
Release
Die Pins
Die Base
2
Reverse this procedure to reinstall the Punch Arm.
2-6
Figure 2-4: Accessing the Die Pins
Pressure Bar
Lift Pressure
Bar in this
direction
General Procedures