Texi Integra 5 Manual Del Usuario página 108

EN
Note: When Prevent cutting plate is installed, the upper looper must be in.
3.
The hand wheel rotates along the direction of the arrow until upper looper
screw A in the highest position, tighten the screws A, closed the upper knife
(engage with lower knife to make it work), push the prevent cutting plate
forward. Transfer change feed dog to "S" position, needle to highest position, lift
presser foot. Remove the cover stitch presser foot and Needle plate, reinstall the
standard presser foot and Needle plate, close the looper cover.
108
Sew coverstitch and 2-threads chain stitch.
Prevent cutting plate:
The prevent cutting plate is marked with a number of
digits. The left side is in millimeters and the right is in
inches. The number indicates the distance between
the needle and the edge of the fabric.
1. Prevent cutting plate assembly and disassembly.
2. Remove the prevent cutting plate from the
accessory box and place it in the corresponding
position of the looper cover. the prevent cutting
plates marked with a number of digits. The left
side is in millimeters and the right is in inches.
The number indicates the distance between the
needle and the edge of the fabric.
Iron on the fabric before sewing, ironing 0.5 cm more
than the width of the seam.
Note: The guide (for coverstitch) is in the accessory
box. You can use it to sew without ironing the
material.
Texi Integra 5