Add Gel And Place Transducer - Bioventus EXOGEN Manual Del Usuario

If You Have a Cast
1. Your cast will have a plastic port with cap
built into it.

Add Gel and Place Transducer

Note: Some patients have experienced mild skin irritation caused by skin sensitivity to the gel.
If you feel your skin is sensitive to the gel, you may change the gel to mineral oil or glycerin.
Add gel on the transducer every time you treat your fracture.
1. Take the cap off the gel bottle.
2. Hold the transducer so the cord is down
and the smooth side of the transducer is up.
3. Press down on the gel bottle nozzle
to put gel on the smooth side of the trans-
ducer. You only need one full
pump of gel on the transducer. (Note: The
first time you use the gel, you may need to
pump a few times to start the gel flowing.)
Labeling LBL-000319 [D] RELEASED
2. Use 2 fingers to squeeze the cap tabs
together to open the cap.
4. Put the transducer, gel side down, into the
port. The gel will be touching the skin over
your treatment site.
3. Pull out the round felt plug inside the open-
ing.
5. Align the cord coming out of the transducer
with the notch in the cap. Snap the cap shut
on the strap or the cast.
6. Replace the cap on the gel bottle.
» Continue to "First Use"
or "Start Treatment"
8