Risk Of Injury - Abicor Binzel ABIPLAS WELD CT Serie Instructivo De Servicio

6 Putting into operation
6.1 Equipping the torch body
1-2
Fig. 3 Steps of equipping the torch body ABIPLAS
EN - 10
NOTE
• The ABIPLAS
operation by trained personnel.
ABIPLAS
CAUTION

Risk of injury

Through-hole or puncture caused by tungsten electrode tip.
• Do not reach into the danger zone.
• Wear protective gloves.
3-4
1 Slide centring ceramics over the tungsten electrode.
2 Insert tungsten electrode with the blunt end first into the torch cap about
5 mm deep.
3 Slide all parts into the torch body and screw down with torch cap.
4 Unscrew screwed-in torch cap half a turn counter clockwise.
5 Slide alignment gauge into the torch body from below as as it will go. This
pushes the tungsten electrode tip back to the setting dimension.
6 Tighten torch cap. Tungsten electrode is clamped.
7 Unscrew alignment gauge and insert insulating ring.
8 Screw in gas diffuser.
9 Screw plasma nozzle firmly into the torch body using the alignment gauge.
10Screw gas nozzle onto gas diffuser.
®
WELD CT welding torches may only be put into
®
WELD CT
150 CT20
5-6 7-8
®
WELD CT 150 CT20
®
ABIPLAS WELD CT
9 10