Start-Up; Opening Door; Loading - Alliance Laundry Systems S Serie Instrucciones De Funcionamiento Y Programacion

Operation

Start-up

Turn on the main power source (circuit breaker
or cut-off switch on the wall).
An identification code will appear for
approximately five seconds. Then the display
will flash "Hold" for thirty seconds.
The display will then read "CY" followed by a
two-digit cycle number (01–30) to indicate
that a cycle can be selected. This display will
be shown at all times that power is on between
cycles, indicating that the door-unlock
solenoid will function if the door-unlock
button is pressed. The machine is then ready
for loading and unloading.

Opening Door

Use left hand to press and hold the door unlock
button located on the lower right front of the
control panel. Use right hand to turn door
handle clockwise and swing the door left to
open. See Figure 2–3.
Figure 2–4
16

Loading

CAUTION
Be careful around the open door,
particularly when loading from a level
below the door. Impact with door edges
can cause personal injury.
Load the machine to full capacity whenever
possible, but do not exceed the rated dry-
weight capacity of the machine if the fabric to
be washed is quite dense, closely woven, and
heavily soiled. Overloading can result in an
inferior wash. The operator may need to
experiment to determine load size based on
fabric content, soil content, and level of
cleanliness required.
Partial loads are a waste of energy, water, and
chemicals, and cause greater machine wear
than full loads. Partial loads also increase the
possibility of a severe out-of-balance
condition.
WARNING
Never operate the machine with a bypassed
or disconnected out-of-balance switch.
Operating the machine with severe
out-of-balance loads could result in personal
injury and serious equipment damage.
When loading is complete, ensure that all
fabric is inside the basket. Then close and lock
the door. The machine should not start or run
unless the door is both closed and locked.
SW025
SW010
F232087