Husqvarna CL400 Manual De Uso Y Mantenimiento página 19

Máquina de cableado profesional
Ocultar thumbs Ver también para CL400:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Blocking the adjustable pin
When laying cable for long straight tracts, the adjustable pin (fig.14) can be locked in place in order
to provide for better management of the machine's advancement direction. In order to lock the pin
in place, just tighten the handle on the right side of its support (fig.14, no.1).
Adjusting the width of the wheelbase
Both of the wheels are equipped with half‐axles which can be extended to 4 different
positions. This system provides for the possibility of obtaining a distance of 25, 27, 29 or 31
cm between the cutter and the edge (fig.15). This ensures that the cable will be laid at an
equal distance from any border, wall or hedge. In order to adjust this distance, just remove
the locking pin (fig.15 no.2) and reposition it in one of the 4 holes along the half‐ axle (fig.15
no.1). Be sure to reset the safety spring.
Starting work operations
Once the cable bas been mounted and the cutter has been installed, the cable must be tied to the ground. In order to
perform this operation, just insert a spike or peg into the ground and tie the end of the cable, which is sticking out of the
bottom of the pin, to it. This operation ensures that the cable will be properly laid within the groove created by the cutter
for the first few meters.
Finishing work operations
Once the work operations have been completed, bring the gas throttle (fig.1 no.3) to its STOP position in order to shut
off the motor (the motor can also be shut off by means of the stop switch, if installed, after having brought the motor's
speed to minimum). Once the motor has been shut off, close the fuel tap. Once the machine has been brought to its
storage location, the cutter's support must be cleaned and lubricated (see the following section).
It is recommended to properly clean the cable laying tube, removing any dirt residues from inside.
Installation of the boundary cable
1. Put the cable through the first ring (A).
2. Gently lift the rubber wheel (B) and insert the cable on the guide below.
3. Push the cable through the second ring (C).
4. Insert the cable through the rubber pipe (D) and through the feeding fin.
Fig.16
19
Fig.17
English
Fig.14
Fig.15
Tabla de contenido
loading

Tabla de contenido