Husqvarna CL400 Manual De Uso Y Mantenimiento página 16

English
CL400
User instructions
Before starting the motor and before starting using it, carry out all the following controls:
•
Check the integrity of the exit hole of the perimeter wire from the cable guide (feed) (fig. 2). In particular, check
the integrity of the flexible tube inside the cable guide. In the case of any damage, it should be replaced. Also
check that there are no cuts along the contour of the hole of the cable guide, and that it does not have a sharp
or jagged edge. If damaged, replace the cable guide.
•
Make sure that the oil level is not below minimum:
o
Unscrew the cap (fig.1 no.11).
o
Use a rag to clean the dip stick and screw the cap back on.
o
Unscrew the cap again and check whether the oil level falls within the minimum and maximum levels
indicated. If the oil level is below minimum, add more oil until a suitable level is reached. (ask a trusted
supplier for a suitable oil typology).
•
Make sure that all of the screws are tightened properly.
•
Make sure that all of the levers are in their neutral positions (fig.1 no.6/no.9).
•
Clean the air filter of any obstructions (see the motor's manual).
•
Refuel the machine through its filtered fuel opening.
•
Open the fuel tap (see the motor's manual).
•
If the motor is cold, the gas throttle (fig.1 no.3) must be set to its START position.
fig. 2
ATTENTION!!! THE MOTOR OIL DOES NOT COME SUPPLIED WITH THE MACHINE
1 Fuel cap
2 Motor starter handle
3 Gas throttle
4 Cutter activation regulator
5 Advancement regulator
6 Cutter activation lever
7 Handlebar swing‐action control lever
8 Swing‐action control regulator
9 Advancement activation lever
10 Cable spool
11 Motor oil cap
12 Meter counter
Fig.1
16