Measuring Weight With A Walker - Philips Patient Telemonitoring Set Instrucciones De Uso

Device Usage
Measuring If it is necessary to use a walker to steady yourself on the Scale, use the
Weight with a following procedure for either the Standard Scale or Steady Scale.
Walker
Standard Scale
Step 1.
side of the Scale platform as shown opposite.
Step 1.
Step 2.
Note You must remove your hands from your walker for the Scale to take your
true weight.
Step 3.
Notes You will not hear the voice prompt if the volume is set to 0.
After several seconds, the Scale will say "Please step off the Scale".
Step 4.
Step 5.
About 5 seconds after you step off the Scale, the Scale will say your final
weight (unless the volume is set to 0).
The Scale then turns off by itself.
Notes If the batteries in the Scale are weak, the Scale's display will flash Lo
and batt alternately instead of Walking "-".
If this message appears on the display or the voice is silent even though it
is not set to 0, change the Scale's batteries following the Replacing
Batteries procedure on page 3-4.
2-22
Philips Telemonitoring Set
Place the walker so its legs are on either
Step on the Scale and stand using the walker
arms for balance.
– Stand as much in the center of the platform as
possible.
– Try not to step on the corners; you might
damage the Scale.
Remove your hands from the walker arms.
The Scale will say, "Please stand still". Do not move.
Walking "-" will show on the display during the measurement.
Grasp the walker arms.
Step off the Scale.