General Information About The Volcano Hybrid; Unpacking; Installation; Care And Maintenance - STORZ & BICKEL HYBRID Volcano Modo De Empleo

6 . GENERAL INFORMATION ABOUT THE VOLCANO HYBRID

6.1. Unpacking

Take out the Hot Air Generator and the
accessories from the box. Immediate-
ly after unpacking check whether the
Hot Air Generator, the accessories, the
Power Cord and the power plug are all
included in the delivery and work prop-
erly. If you notice any defects, inform
the seller or the delivery agent imme-
diately.
The packaging
(plastic
parts, cardboard boxes, etc.)
must not be made accessible to chil-
dren as they pose a potential danger.
Please dispose of the packing material
in a proper and environmentally friend-
ly manner.
We recommend keeping the original
packaging in case it is required later
(transport, Storz & Bickel Service Cen-
ter etc.).

6.2. Installation

Before installing the Hot Air Generator,
make sure that the information given
on the type label on the underside of
the device corresponds to the local
mains supply data. All parts of the
electrical system must comply with
currently applicable official regula-
tions.
elements
bags, polystyrene
Put the Hot Air Generator on a flat and
stable surface.
Take care that the Power Cord cannot
be damaged through kinking, crushing
or pulling.
Improper
lead to personal injury or ma-
terial damages, for which the
manufacturer cannot be held
responsible.

6.3. Care and Maintenance

Before any maintenance work is done,
the device has to be switched off and
the power plug has to be unplugged
from the power supply.
At the bottom of the Hot Air Genera-
tor is an Air Filter. The Air Filter must
be inspected for contamination every
four weeks by turning the Air Filter Cap
counterclockwise and remove the Air
Filter. Open the rectangular flap and
replace the Air Filter.
Please pay attention to the cor-
rect positioning of the Air Filter:
it has three large and one small
rounded corner.
70
installation may