Connecting Via Wirelesshart ® Interface; Mechanical Installation; Installing The Gas Detector - Installation Without Mounting Accessories; Installing The Antenna - Dräger Polytron 6100 EC WL Instrucciones De Uso

®
4.2.1.3 Establish Bluetooth connection
Prerequisite:
®
– Bluetooth interface on the gas detector and on the Windows
device is activated.
– A pairing was implemented between the gas detector and Windows
terminal device.
● Connect via PolySoft.
Entering a PIN is not necessary.
✓ After successful connection, the blue LED lights up continuously.
®
Gas detector and Windows terminal device with PolySoft are connected.
4.2.2 Connecting via WirelessHART
®
● Connect Windows terminal device to the respective management station of
®
the WirelessHART network.
The device is configured via the WirelessHART
description (DD) or the device type manager (DTM).
5

Mechanical installation

WARNING
Risk of explosion!
In explosion-hazard areas, electrostatic discharge may cause a spark to ignite
on the antenna.
► Do not install the antenna in explosion-hazard areas subject to intense
electrostatic charging, for example, due to fast moving particles or
pneumatic transport of powders.
WARNING
Risk of explosion!
In explosion-hazard areas, electrostatic discharge may cause a spark to ignite
on the housing and sensing head.
► Do not install the gas detector in dust explosion-hazard areas subject to
intense electrostatic charging, for example, due to fast moving particles or
pneumatic transport of powders.
Instructions for use |
Dräger Polytron
®
terminal
®
®
interface
®
network with the device
®
6100 EC WL, Dräger Polytron
5.1 Installing the gas detector - installation
without mounting accessories
The gas meter is installed vertically on a flat surface with the antenna facing
upwards.
For installation with mounting accessories, see corresponding assembly
instructions.
Prerequisites:
– A suitable installation location is selected (see "Safety information", section
"Mechanical installation", page 38).
CAUTION
Risk of explosion!
The gas detector is not tested in environments with increased oxygen content
(> 21 % O ).
2
► Do not use the gas detector in environments with increased oxygen content.
Install the gas detector:
● Install the gas detector using the drilling template (see appendix "Drilling
template") and M6 (1/4") hexagon socket head cap screws.
5.2

Installing the antenna

1. Remove the cover cap from the antenna connector (Fig. A 4).
2. Screw the antenna into the connector and tighten it by hand.
5.3

Installing the remote antenna

1. Remove the protective cap for the antenna on the connection (Fig. A 4).
2. Screw antenna cable to connection and tighten hand-tight.
3. Select an installation location where a perfect signal transmission is
ensured. The antenna must point up vertically.
4. Attach the mounting bracket at the installation location of the remote
antenna.
5. Lay the antenna cable.
®
Repeater WirelessHART
|
Mechanical installation
®
en
43