Utomatic Mode; Activating And Deactivating Automatic Mode; Brake Dynamometer Test Sequence - Bosch BSA 42 Serie Instrucciones De Funcionamiento

6. Automatic mode
i
Automatic mode is recommended for rapid
performance of one or more measurements not
requiring verification of the measured data.
6.1 �ctivating and deactivating automatic mode
Step
¶
Automatic mode activation.
¶
Automatic mode deactivation.
6.�

Brake dynamometer Test sequence

Step
1. Check prerequisites:
R
No vehicle on dynamometer!
R
Test routine selected.
R
"Automatic" mode selected.
2. Drive vehicle onto dynamometer.
¶
With the axle to be measured first and keeping the
vehicle straight.
¶
Disengage gear.
¶
Release brake pedal.
!
If the vehicle is not straight on the set of rollers,
it will slide off to the side. Counter-steer until the
vehicle returns to straight position on the set of roll-
ers. Measurement is not to be started before this has
been done.
i
It may be necessary to drive off the set of rollers and
then drive the vehicle back on.
3. Automatic brake test commences.
i
Measurements are only possible on an axle basis in
Automatic mode.
Robert Bosch GmbH
Principal features:
R
Test sequence can be selected by user.
R
Automatic starting of measurements.
R
No storage of measurement results.
R
No print-out of measurement results.
�nalog display Remote control
unit
Press for
1 second
Press for
1 second
Result / �nalog display
? Warning lamp ON.
? LCD
Drive-on prompt.
? Axle to be measured is positioned on set of rollers.
? If use is being made of axle load scales (special ac-
cessory):
LCD indicates axle load (kg).
? Announcement phase:
$
Warning lamp flashes, device symbol flashes.
$
The dynamometer motors start up,
the test rollers turn.
$
The rolling resistance is measured.
? Ready for braking force measurement.
? Warning lamp ON.
�utomatic mode | BS� ���� | �7 BS� ���� | �7
Result / �nalog display
? Warning lamp ON.
? LCD:
Auto on
? Warning lamp OFF.
? LCD:
Auto oFF
1 691 506 010
| �7 en
|
2009-05-25