Operation; Before Startup - Kärcher G200FA Manual Del Usuario

 Risk of burns! Do not touch hot muf-
flers, cylinders or radiator ribs.
Allow the engine to cool down prior to
storing it indoors.
 Do not put hands or feet close to mov-
ing or rotating parts.
 Do not touch the ignition cable or the
spark plug while the engine is running.
WARNING
 Except for setting jobs, do not run the
engine when the air filter is removed or
there is no cover over the suction sup-
port.
 In case of damage or leaks on the fuel
system, do not use the engine. Check
the fuel system regularly and replace
damaged components.
 The safety instructions in this manual
cannot cover all operating situations.
Make sure you observe all safety in-
structions during maintenance and op-
eration.
CAUTION
The radiator ribs and the starter rope must
be free of grass and other dirt to avoid fires
or damages to the engine.
ATTENTION
 Use original parts of the engine manu-
facturer only. Other parts could damage
the engine and shorten its service life.
 Only use fresh fuel. Old fuel can cause
residue in the carburettor and affect the
engine's performance.
 Do not pull on the starter rope while the
engine is running to avoid damage to
the starter.
Description of the Appliance
Illustration
1 Muffler
2 Oil filling screw with oil dipstick
3 Oil drain screw
4 Engine switch
5 Starter rope
6 Fuel cock
7 Choke
8 Air filter
9 Spark plug
10 Fuel tank
11 Fuel tank lid

Before Startup

Illustration
 Switch off engine switch.
 Check the engine for oil or fuel leaks.
Remove existing leaks.
 Check and ensure proper fitting of all
screw connections. Tighten loose con-
nections.
 Check the areas around the muffler and
the starter for dirt. Remove existing
contamination.
 Park the machine on an even surface.
Illustration
 Check oil level.
(details in the chapter Maintenance)
ATTENTION
Never operate the engine without the air fil-
ter, as this will lead to increased wear.
 Check the air filter for dirt and damage.
Clean air filter as needed, depending on
the degree of contamination.
 Unscrew the lid of the fuel tank.
Illustration
 Fill in fuel.
Maximum filling level up to the shoulder
of the filter.
– 2
EN

Operation

15